Energy Efficiency

Say YES to Savings by Using These Energy Saving Techniques

All we want from our home appliances are efficient output and energy saving. The former can be achieved by choosing the best-in-class products. But, the latter is a bit tricky. There has to be some standard proceeding to execute the maintenance of your home appliances like a solar system or a water heater. Today, let’s give attention to some energy saving techniques which help you in saving your budget as well.

A water heater requires special care as compared to any other electronic device. Although manufacturers avail the best components that can bear the constant heat and cooling, you have to keep in mind that even the best components will erode if put under constant pressure. These are some tips on keeping your water heater healthy.

Place the water heater at an appropriate height

Specialists suggest that you should install the geyser at a height not less than 6 feet from the floor. This makes sure that the water pressure is adequate and you get a suffice hot water stream in your tap.

Electrical connections Precautions

Your technician for hot water repairs in Sydney should safeguard that a Miniature Circuit Breaker (MCB)comes before the connection of the water heater. So that it disconnects electricity in case of power variations. This minimizes the odds of any short circuit in the water heater. Moreover, keep the water heater switch at a considerable height away from the reach of children.

Check Pressure Valves

Lookout if the temperature and pressure release valves are functioning properly or not. This inspection should be done once a year. You can monitor this by freeing the pressure once or twice. It is a frequent problem if the relief valve at the water heater is leaky. You have to ditch some water out of your water heater and eliminate the discharge tube. Afterward, you can replace the valve.

Just like the water heater, we also have some suggestions on the maintenance of the solar system. Solar rooftops are a new addition to the appliance list of a house owner. If you have a solar setup at your rooftop, then you must have a look at these bullets.

They are used to be put under the sun!

It is obvious that solar panels should always be facing the sunlight. Set solar panels beyond shade as solar energy generation becomes unproductive when they are away from absorbing the sunlight.

Supervise the inverter LED often

Constantly monitor the solar panels and ensure that the inverters are indicating green lights. If they are not indicating, you are no longer reimbursing for your electricity use. This means that your installation of a solar rooftop is in vain. Tell your technician for Solar System repair in Sydney to check the fault in the inverter and rapidly recover that.

The solar Panel Should be Neat and Clean All the Time

Always detect and remove mud or dust particles on the solar panels to ensure that it doesn’t build up since they cannot absorb sunlight at full throttle with the surface being dirty. Clean the dirt at regular intervals.

Be Safe while Working with Solar Panel Maintenance

Safety comes first! To keep yourself and others safe while maintaining a solar panel, employing adequate wiper length to perform cleaning activities on the panels while you are on the ground level. If this cleaning is a routine, you can also just use a blower or hose beside the panels to remove any dust and dirt Particles. Fewer calls on solar panel maintenance.

Do not Use Edgy Cleaning Agents for Solar Panels

Do not make the mistake of using a scratchy abrasive sponge or soap while cleaning your solar panel. You may scratch the glass in this process. The most suitable material for cleaning solar panels is an easy rag or biodegradable foam which is not harsh in the glass surface.

By keeping these points in your conscience, you can retain your home appliances for a long period of time and also achieve great efficiency in working with them. After all, you would not like maintenance work at your place every day!

Write A Comment